Professional Manufacturer Boost Step up High Voltage Pulse Inverter Arc Generator Ignition Coil Module DC 3-6V 1000kv Boost Step-up Power Module

Basic Info.ApplicationElectronicPhaseSingleCoreCore-type TransformerCooling MethodDry-type TransformerWinding TypeAuto-transformerCertificationISO9001-2000UsageSingle-phase TransformerFrequency CharacteristicsHigh FrequencyBrandTianwangInput Voltage4.8VDCOutput Voltage33kvApplicabilityNegative-Ion Generator, Self Defense EquipmentWeight75gTrademarkTWTransport PackageCartonSpecificationCEOriginJiangsu Province, ChinaProduct Description  PRODUCT INTRODUCTION              High voltage pulse GeneratorThis module is a high-voltage inverter for the science production, the finished module of the transformer/boosterAfter inputting DC4.8V voltage at the input terminal, DC high voltage of tens of thousands of volts can be obtained at the output end.It can output high voltage pulse current, small size and high efficiency.It can be used for negative-ion generator, electric fence, and science experiment.The peripheral circuit is simple, simply connect to switch and battery, and the discharge intensity is great. Product namepulse HV generatorModelTW-G-AF-1101Input Voltage4.8VDCOutput voltage30KVDCWorking Current3AIgniting distance14mmInput Line Diameter1.2±0.03mmInput Copper wire0.15 mm x 11Φ rootOutput Line Diameter1.6±0.03 MMOutput Copper wire0.15 mm x 7 Φ rootInput Line Length72MMOutput Line Length120MMSizeL25xW21.5xH71 MMWeight60±1g1.This module is a high voltage generator made of the circuit composed of components and high voltage transformer,which can be used as a high voltage source for student science experiment, electronic instrument, negative ion generator, etc. 2. Based on the coil principle, the module outputs high-voltage pulse, featuring small volume, high efficiency and fiercedischarge intensity. 3. The module is divided into input end and output end. The red and black wires are the input end, and red one is positive pole, black one is negative pole. The output end is two high voltage wires in the same color. High voltage arcs can be generated by connecting the input end to the battery. 4. Avoid power-on when no load under high voltage. The distance of high voltage discharge end should be adjustedproperly before power-on, and the arc distance of the output end is proportional to the voltage and capacity and the used battery. 5. The arc distance should be tested from short to long. It is strictly forbidden to exceed the maximum arcing distance of  the module. Because the high voltage energy cannot be released, the module is easily damaged. 6. The module has high power and inner heat dissipation is not good, so it can not work for long time.  Features:This module generate very high voltage,can be seen DC 3V - 7.2V can generate 20-100KV DC high voltage (about 1-2 cm arc) at the output can be used as high school science experiments , electronic equipment, negative ion generator, high voltage source to use when making small science.