Gcs Hot Selling Low Voltage Withdrawable Enclosed Power Distribution Switchgear

Basic Info.Model NO.GCSCertificationISO9001Shell MaterialStainless SteelVoltage LevelLow VoltageInstallationFixedStructureFloorstandingCurrentACModel NoGcsVoltage380-660VRated Short-Time Withstand Current50-80kaApplicationIndustrial AutomationFunctionUndervoltage ProtectionItemElectrical Auto ResetWarranty1 YearTrademarkCHlelQUSpecification800-800*2200mmOriginChinaProduct DescriptionProduct DescriptionGCS low-voltage withdrawable type complete switchgear (hereinafter referred to as the "switch equipment") is my company to meet the requirements of the design unit and power users design developed in line with the national conditions, with high technical performance indicators and can adapt to power market development needs and can compete with the introduction of existing product low voltage draw-out switchgear.This product has been widely used by power users.Switchgear is suitable for power plant, petroleum, chemical, metallurgy, textile, high-rise building and other industriesdistribution system.In large power plants, petrochemical systems and other places with high degree of automation and requiring computer interface, itis used as a low-voltage complete power distribution device for power distribution, centralized control of motors and reactive power compensation in power generation and power supply systems with three-phase AC frequency of 50(60)Hz, rated working voltage of 380V(400V), (660V) and rated current of 4000A or below.The basic form of switchgear (see figure 1). This product conforms to the standards of GB7251 low voltage switchgear and control equipment, JB/T9661 low voltage draw-off switchgear and IEC439 low voltage switchgear and control equipment. Detailed Photos Specification Rated voltage of main circuit(V) AC380(400),(660)Rated voltage of auxiliary circuit(v) AC220,380(400)  DC 110,220Rated frequency(Hz) 50(60)Rated insulation voltage(v) 660(1000)Rated current(A)Horizontal busbar4000Vertical busbar (MCC)1000Rated short time withstand current of busbar (kA, 1s) 50,80Rated peak withstand current of busbar (kA, 0.1s) 105/176Power frequency test voltage (V/1min)Main circuit2500 Auxiliary circuit1760Bus barThree-phase four-wire systemA,B,C,PE.NThree-phase five-wire systemA,B,C,PE.NProtection level IP30.IP40  THE USE OF CONDITIONS1.Temperature of ambient air: -5°C~+40 pairs;The average daily temperature shall not be higher than +35°C.In case of excess, the capacity shall be reduced according to the actual situation.2.Altitude: 2000m and below.3.relative humidity: the maximum temperature of +40P is not more than 50%, at a lower temperature allowed to have a large relative humidity: such as +20P is 90%, should take into account the temperature changes may occasionally produce the impact of condensation.4.The mounting incline shall not exceed5.and the whole group of cabinets is relatively flat (in line with GBJ232-82 standard).5.Switchgear should be installed in places free from severe vibration and shock and not enough to cause undue corrosion ofelectrical components.Note: users have special requirements, can negotiate with the company to solve.PRODUCT STRUCTURE CHARACTERISTICS1.The main frame is made of 8MF type open profile steel, with 9.2 mm mounting holes with modules of 20 mm and 100 mm on both sides of the profile steel, allowing for flexible internal installation2.The main frame assembly is designed in two forms, a fully assembled structure and a partially welded structure (side frame and beam), for user selection3.The functional rooms of the device are isolated from each other, and the isolation rooms are divided into functional unit rooms, busbar rooms, and electrical building rooms. The functions of each room are relatively independent4.The horizontal main bus is arranged horizontally behind the cabinet to enhance the electrical resistance of the bus, which is a basic measure to make the main line of the device deviate from the short-circuit resistance capability,5.The design of the cable compartment is very convenient for cable entry and exitCompany ProfileHangzhou hui di electrical technology CO.,LTD. is a professional development and production of distribution boxes, power cabinets, low voltage cabinets, non-standard automation control system of boxes, stainless steel boxes, the end user boxes, information boxes, such as power transmission and distribution products of high and new technology enterprise, at the same time operating sales of electrical and mechanical equipment,instruments and meters,power transformer,wire and cable.Company existing staff of 70 people, include sales personnel, technical personnel, after-sales service personnel. Company adhere to the "intelligent, science and technology and industrialization" development strategy, vigorously promote scientific and technological innovation, management innovation, system innovation, for the domestic and foreign customers with high performance, high quality professional quality services.Our products involved field widely, in