High Density Telephone Kraft Paper Covered Round Copper Wire for Transformer Coil

The windings of large power transformers use combined conductors or transposed conductors, which can greatly reduce the load loss, reduce the temperature rise of winding hot spots, improve the mechanical strength of the windings, make the structure more compact, and make the coil processing easier. It has been widely used in the design and manufacture of large power transformer windings. The composite wire is composed of several insulated magnet wire or copper and aluminum wires arranged according to the specified requirements. The winding wire is wrapped by a specific insulating material.Transposed conductor refers to the combination of a number of enameled copper flat wires into two rows with wide surfaces in contact with each other, and according to the requirements on the top and bottom of the two rows of enameled wires along the narrow side of the same direction of transposition, and electrical insulation tape is used. As a multi-layer continuous and tightly wrapped composition The windings of large power transformers use transposed conductors, which can greatly reduce load loss, reduce the temperature rise of winding hot spots, improve the mechanical strength of windings, make the structure more compact, and make coil processing easier. It is widely used in winding design and manufacture. In the production process of transposed conductors, there will be a problem of poor external dimensions of the transposed conductors. It is often found after the next process that it is irreversible, so that the product cannot be reordered. Winding process processing, adjusting the insulation structure affects the efficiency and product quality. Therefore, it is urgent to solve the existing problems of the large width and height of the transformer winding transposition wire, which is to solve the unqualified quality problem that the wire causes the transformer coil radial and lateral diameter to increase. Analysis of two factors affecting equipment and processing methods:1. The transposition head stop number of the transposition wire production line is not suitable. In the production, the transposition head stop is used according to the wire gauge. The transposition distance is large, the tightness of the transposition wire is reduced, and the size will be larger. It is one of the main factors that lead to the poor size of the transposed conductor. 2. Although the size of the insulated magnet wire is within the qualified range, for products with a small winding coil diameter and a large number of enameled wires per transposed conductor, the external dimensions of the transposed conductor are likely to be poor. It is two of the main factors that lead to the difference in the external dimensions of the transposed wire.3. The mold size control is not suitable. Although it is within the qualified range, the size of the mold size repaired for a batch of products is the upper deviation, which is one of the main factors leading to the difference in the external dimensions of the transposed conductor./* January 22, 2024 19:08:37 */!function(){function s(e,r){var a,o={};try{e&&e.split(",").forEach(function(e,t){e&&(a=e.match(/(.*?):(.*)$/))&&1