Environmental Protection Waste Gypsum Red Mud Rotary Dryer Equipment

                                                                       Red Mud Rotary Dryer  Product Description Red mud dryer is also known as the three layers of drum dryer, three return cylinder dryer, on the basis of the single cylinder dryer, developed and manfactured,which is an industrial dryer on non-viscous, liquid material .At present three-cylinder dryer made by Dingli company,with mature technology, throughthe drying of the sand, fly ash, coal, mineral materials, slag and other material , the effect is very good.Product Features 1. The red mud dryer is made of alloy steel plate manufacturing,the wear-resisting 3-4 times of ordinary steel , the service life of the equipment is more than 10 years.2. Material initial moisture content 15%, final moisture to ensure below 0.5-1%,which is the preferred products of the cement plant, GGBS and dry mortar production line.3. The sand dryer thermal efficiency is as high as 80%, at the same time, the total power is low, 40% energy saving.4. The fuel can be adapted to the coal, oil, gas,it can be dried under 20-40mm particles material, aggregate, powder material.5. The red mud covers an area of about 40% lower than single drum dryer and civil investment reduced by about 50%.6. No air leakage phenomenon, solved the sealing difficulties, modular units, installation is convenient.7. The discharge temperature is < 50 ºC,which can be directly feed libraries, without cooling.8.The system uses PLC technology to achieve centralized automatic control, convenient operation and reliable performance.  Working Principle After the red mud enters the drying drum, it is divided into the following working areas: One is the guide area. The red mud enters this area and quickly evaporates water in contact with the high temperature hot air. The red mud does not form a bond under the movement of the guide plate with a large lead angle. Then it is led to the next lower production area: the second is the pick-up cleaning area, where the wet material is picked up by the pick-up board to form a material curtain. When the red mud falls, it is easy to form a sticking drum wall phenomenon. In this area, due to the equipment design The cleaning device, the cleaning device cleans the red mud adhered to the inner wall very reasonably. In this process, the cleaning device also breaks the agglomeration of the red mud balls, thereby increasing the heat exchange area and increasing the drying rate: It is an inclined lifting plate area, where the wet red mud is already in a low-moisture and loose state, and the red mud has no adhesion phenomenon in this area. After sufficient heat exchange, the red mud reaches the required moisture state and enters the discharge area : The fourth is the discharging area. The drum is not equipped with a copy board in this area. The red mud rolls and slides to the discharge port in this area to complete the entire drying process.  ApplicationsDryers are widely used in building materials, metallurgy, mineral processing, chemical, cement and other industries. They can be used to dry slag, calcium carbide slag, limestone, clay, river sand, quartz sand, water slag and other materials.  Product Parameters  Model(m)Output (T/h)Coal consumption kg/tTotal powerRiver sandFly ashMineral waste residueΦ2.0×24-52-33-512-145.5kwΦ2.0×48-124-68-1012-143kw×2Φ2.0×512-156-710-1310-124kw×2Φ2.2×4.514-187-912-1510-125.5kw×2Φ2.5×623-2810-1320-2210-125.5kw×4Φ2.8×630-3515-1825-3010-125.5kw×4Φ3.0×635-4018-2032-358-107.5kw×4Φ3.0×740-4520-2535-408-107.5kw×4Φ3.2×745-5025-3040-458-1011kw×4Φ3.2×850-5530-3545-508-1011kw×4Φ3.6×860-7035-4060-656-815kw×4Φ3.8×970-8040-4570-756-815kw×4Φ4.0×1090-10045-5080-906-818.5kw×4Φ4.2×8.580-10045-6080-906-818.5kw×4(The output is set according to moisture: dry from 15% to 1-3%)   Successful Cases The sand dryer ordered by Hunan customers applies Jiutian's newly developed drying technology. At the same time, it combines the characteristics of sand with special equipment to dry the sand to the customer's demand.If you want to learn more about sand dryer cases and view videos, please contact us! Package & Delivery  Company Profile Zhengzhou Jiutian Machinery Equipment Co., Ltd. dryer products cover all kinds of slime products such as coal slime, dregs, biomass, organic fertilizer, sludge, yeast, coconut fiber and chaff, and coconut. At present, the company not only has a huge customer resource system and considerable market share in the country but also in the UK, Russia, Greece, Italy, Israel, Morocco, Congo, Egypt, Côte d'Ivoire, Madagascar, Australia, India, Vietnam, Laos, Indonesia, Malaysia. In many overseas countries such as Sri Lanka, Chile, and the United States, the dryer case was established and successfully put into operation, and the quality and technology of the dryer products were in line with international standards.   FAQQ1. Quality controlAll the sand drying equipment offered by Zhengzhou Jiutian Technology Machinery Co., Ltd. are produced by China n