10km 11AC 5GHz 900Mbps Wireless Bridge, Ptp Ptmp

Detailed Photos Product DescriptionCPE-890DH is an high power industrial 5G outdoor CPE with 10KM PTP/PTMP range. Comply with the next generation 802.11ac Wi-Fi standard, Qualcomm Chipset, combined 900Mbps high speed in 5.8G, equipped Gigabit WAN port, 3 times Ethernet data rate faster than 300Mbps model; It with LED display to show and configure CPE's operation mode, Channel, IP address and Signal Strength, simple to do the Point to Point connection by reset button, no need to access into GUI.900Mbps Data Rate & Gigabit WAN/LAN Ports CPE-890DH features 802.11ac Wi-Fi and 2*2 MIMO technology, 900Mbps wireless speed. Equipped with Gigabit Ethernet port ensures high speed internet access and more end users access.5GHz frequency, more channels, lower latency, higher stabilityCPE890DH with full frequency of 5020~6100MHz, more than 200 channels available, it avoid the frequency interference problem, full meet with data transmission in fast speed, low delay, high stability requirement in wireless security or data transmission.10KM PTP/PTMP Distance  Designed in two line Power Amplifier on PCB board, the power can be 500mW high power, 18dBi MIMO high gain panel antenna, greatly increase the Wi-Fi range to 10KM distance, then supply the stable Wi-Fi signal for users. LED DisplayCPE-890DH with LED display to show AP/Client operation mode, Channels, IP address and RF Power; What's more, it is easy to setup CPE-890DH operation mode, IP address, Channels by set switch on product, no need to access into GUI, avoid the complex setup program, simple to check the working status.Power over EthernetCPE-890DH has integrated passive Power over Ethernet (PoE) (IEEE802.3af 48V PoE is optional), for easy installation and lower cost. So it can be installed in areas where power outlets are not readily available, eliminating the mess of altering existing network infrastructure.Main Features: Comply with IEEE 802.11ac/a/n, 5GHz,900Mbps Data Rate1*10/100/1000Mbps WAN Port, 1*10/100/1000Mbps LAN Port500mW high power, build in 18dBi MIMO panel antenna, stronger signal strength, more wireless coverageSupport passive PoE 24V; 48V IEEE 802.3af PoE is optional Support SSID broadcasting, Muiti SSID up to 4, then support tag VLAN based on SSID. Support Gateway (PPPOE, static IP, dynamic IP), Wireless AP, Repeater, WISP, WDS operation modeWith function of build in firewall, IP filter, URL filter and MAC filter  Comply with IEEE 802.3az standard, RF power adjustment and frequency analyzer for better application in different environmentSupport DDNS, VPN pass through, Port forwarding and DMZ hostSupport 64/128-bit WEP security, 128bit WPA (TKIP/AES) securityProduct Spec.:   Hardware: ChipsetQualcomm QCA9563+QCA9886+QCA8334Standard802.11ac/a, MIMO technologyMemory128MB DDR2 RAM Flash16MBInterface1 * 10/100/1000Mbps RJ45 WAN Port1 * 10/100/1000Mbps RJ45 LAN Port1 * LED display, 1 * F(Function) switch button, 1 * S(Select) button,  press it to setup WDS PTP/PTMP connection1 * Reset button, press 15 seconds to revert to default setting/press 1 seconds to finish the WDS PTP/PTMP connectionAntennaBuild in 18dBi MIMO Panel AntennaPower consumption24V PoE,