Soft Hard Plastic Machine/Plastic Crusher/ PP PE Crusher

Product DescriptionIntroduction:Plastic crushers are mainly used to crush various thermoplastics and rubbers, such as plastic profiles,pipes, rods, threads, films, and waste rubber products. The pellets can be directly used for extrusion andinjection molding.Detailed Photos  Model S-600 S-800S-1000S-1200S-1500 Rotor Blades 8 8 8 8 8 Fixed Blades 4 4 4 4 4 Screen 14/16 mm 14/16 mm 14/16 mm 14/16 mm 14/16 mm Power 30 KW 37/45 KW 45/55 KW 55/75 KW 75/90 KW Capacity 300 kg/h 500 kg/h 800-1000 kg/h 1000-1500 kg/h 1500-2000 kg/hOperation attention of plastic shredder1. The plastic pulverizer and power unit should be installed firmly. If the plastic crusher needs to be fixedfor a long time, it should be fixed on the cement foundation; if the plastic crusher needs to be flown, theunit should be installed on the frame made of angle iron, and ensure that the power engine (diesel engineor electric motor) and plastic The pulley grooves of the crusher are in the same rotation plane.2. After the plastic crusher is installed, check the fastening of each fastener, and tighten it if it is loose. Atthe same time, check whether the belt tightness is appropriate.3. Before starting the plastic crusher, first turn the rotor by hand to check whether the operation of the claws,hammers and the rotor is flexible and reliable, whether there is any collision in the crushing chamber, whetherthe rotation direction of the rotor is consistent with the direction pointed by the machine, and whether thepower machine and plastic Whether the crusher is in good condition.4. Do not replace the pulley casually, in case the rotating speed is too high to cause a crushing chamber, or therotating speed is too low to affect the working efficiency of the pulverizer.5. After the plastic shredder is started, it should be kept idling for 2~3 minutes first, and there is no abnormalphenomenon before feeding work.6. Pay attention to the operation of the plastic crusher at any time during the work. First, the feeding should beuniform to prevent the crushing chamber from being blocked; secondly, do not overload the work for a long time.If it is found that there is vibration, noise, high temperature of the bearing and the body, and material spraying out,it should be stopped immediately for inspection, and the work can be continued after troubleshooting.Machine display After Sales Service/* March 10, 2023 17:59:20 */!function(){function s(e,r){var a,o={};try{e&&e.split(",").forEach(function(e,t){e&&(a=e.match(/(.*?):(.*)$/))&&1