21 Degree Round Head Zinc Galvanized Plastic Framing Nails for Framing Nailer

 21 Degree Round Head Zinc Galvanized Plastic Framing Nails for Framing Nailer        For use in 20 to 22 degree plastic collation framing nailersPlastic collated ring shankHot dip galvanized coating resists corrosion and rust. For interior and exterior use. Rated for use in treated lumberFull round headProduct Description:21 Degree Round Head Zinc Galvanized Plastic Framing NailsNameZinc Galvanized Plastic Framing NailDegree28 degree and 17 degree and 21 degreeDiameter2.87mm(0.113"), 3.05mm(0.120"), 3.33mm(0.121")3.76mm(0.148") 4.10mm(1.60")Length50mm-130mmShankSmooth, Ring, ScrewFinishingBright, EG, HDG, DACR, MechGalv, Heat TreatedCoatingYellow, Red, BlueMaterialSteelCustomizedCustomized is available if you provide a drawing or sampleSamplesSamples are freeOEM ServiceOEM Service is available if you provide a drawing or sample.Related Framing Nailer: DescriptionPACKINGPCS/STRIPPCS/CTNMechanical   Galvanized (MG)2.9X50mm252,000Mechanical   Galvanized (MG)2.9X65mm252,000Mechanical   Galvanized (MG)2.9X75mm252,000Mechanical   Galvanized (MG)3.1X83mm252,000Mechanical   Galvanized (MG)3.1X90mm252,000 Bright2.9X75mm253,000Bright3.05X75mm254,000Bright3.33X100mm252,000Bright3.8X130mm251,000Bright4.6X160mm251,000 Hot Dip   Galvanized (HDG)2.9X50mm252,000Hot Dip   Galvanized (HDG)2.9X65mm252,000Hot Dip   Galvanized (HDG)2.9X75mm252,000Hot Dip   Galvanized (HDG)3.1X83mm252,000Hot Dip   Galvanized (HDG)3.1X90mm252,000 Electro   Galvanized (EG)3.6X25mm254,000Electro   Galvanized (EG)3.6X50mm252,000Electro   Galvanized (EG)3.8X75mm252,000Electro   Galvanized (EG)3.8X83mm252,000Electro   Galvanized (EG)3.8X90mm251,000Electro   Galvanized (EG)4.0x100mm251,000Shank Type:Smooth ShankSmooth shank nails are the most common and are often used for framing and general construction applications. They offer enough holding power for most everyday use.Ring ShankRing shank nails offer superior holding power over smooth shank nails because the wood fills in the crevasse of the rings and also provide friction to help prevent the nail from backing out over time. A ring shank nail is often used in softer types of wood where splitting is not an issue.Screw ShankA screw shank nail is generally used in hard woods to prevent the wood from splitting while the fastener is being driven. The fastener spins while being driven (like a screw) which creates a tight groove that makes the fastener less likely to back out.Annular Thread ShankAnnular thread is very similar to a ring shank except the rings are externally beveled which presses against the wood or sheet rock to prevent the fastener from backing out.Finishing:Bright FinishBright fasteners have no coating to protect the steel and are susceptible to corrosion if exposed to high humidity or water. They are not recommended for exterior use or in treated lumber, and only for interior applications where no corrosion protection is needed. Bright fasteners are often used for interior framing, trim and finish applications.Hot Dip Galvanized (HDG)Hot dip galvanized fasteners are coated with a layer of Zinc to help protect the steel from corroding. Although hot dip galvanized fasteners will corrode over time as the coating wears, they are generally good for the lifetime of the application. Hot dip galvanized fasteners are generally used for outdoor applications where the fastener is exposed to daily weather conditions such as rain and snow. Areas near the coasts where the salt content in rain water is much higher, should consider Stainless Steel fasteners as salt accelerates the deterioration of the galvanization and will accelerate corrosion. Electro Galvanized (EG)Electro Galvanized fasteners have a very thin layer of Zinc that offers some corrosion protection. They are generally used in areas where minimal corrosion protection is needed such as bathrooms, kitchens and other areas that are susceptible to some water or humidity. Roofing nails are electro galvanized because they are generally replaced before the fastener begins to wear and are not exposed to harsh weather conditions if installed properly. Areas near the coasts where salt content in rain water is higher should consider a Hot Dip Galvanized or Stainless Steel fastener. Stainless Steel (SS)Stainless steel fasteners offer the best corrosion protection available. The steel may oxidize or rust over time but it will never lose its strength from corrosion. Stainless Steel fasteners can be used for exterior or interior applications and generally come in 304 or 316 stainless steel. Usage:Construction, Decoration, Furnituring and so onAbout Us:FAQ:1.Q:Do you have your own production factory?   A:Yes,we not only have our own factory,We also have a cooperative relationship with more than one hundred factories in China2.Q: Can you send us samples?   A: We are pleased to send you the sample to test the quality and market. 3.Q: About your products, could you do it OEM?   A: Yes, OEM service is available. 4.Q: Do you also provide spare parts of pneum